Peerless Universal Tilt Wall Mount worked great | Peerless Universal Tilt Wall Mount for 32"- 60" Flat...

Does the job well | Peerless Universal Tilt Wall Mount for 32"- 60" Flat Panel Screen with one Touch Tilt

electronics:


	• Peerless Universal Tilt Wall Mount for 32"- 60" Flat Panel Screen with one Touch Tilt Peerless Peerless average customer review:based on 74 reviews view larger image
	for more information click here

highly recommended

Sturdy but you may need special screws for your TV

The stand is sturdy and comes with quite an assormant of screws for mounting different televisions. I was using it for a Sony W3000 52" TV. It had my TV listed in a book that said which of the sets of screws to use. I tried these and they were too long. It had another set that was the same diameter but they were too short. After reading the manual that came with my telelvision I found out that I needed an inbetween size that did not come with the mount kit. After going to 2 Home Depot's and a Lowes I was unable to find the right size bolts, so I ended up buying a set of washers, and had to use 3 of them for each of the bolts that came with mount kit so that I could tighten them with out poking a hole through the front of the TV. I was actually also surprised with Sony for not including the mounting bolts for their with tv.

for more information click here

Peerless Universal Tilt Wall Mount worked great

I used this product to hang a 50" plasama to the wall. The instructions were very clear and the product works great. I would recommend this to anyone.

Does the job well

This is a well designed mount that does the job. It was easy to install and came with all the hardware needed. There is a sheet that lists all the TVs this mount will work with. Simply find your brand and model and the sheet directs you to the labeled packets of hardware needed for your TV. You may have to visit the Peerless website if your TV is too new to have made the list when the mount was produced. If you have any doubts about which mount you need, the Peerless website will direct you to the correct mounts for your TV.

The one-touch tilt is a bit misleading. You have to loosen a wing nut on each side to adjust the tilt, but it isn't difficult if you have some help. Overall, I would recommend this mount and the price is very reasonable for what you get.

Addendum: The hex head wrench used to lock the TV to the mount was too long to work in my case due to a shelf below the mount. I email customer service and was promtly sent (2 days) 2 shorter wrenches that got the job done. I was very impressed by their customer service.

for more information click here

Peerless ST660 Wall Mount Just So-so for Panasonic TH-58PZ700U Plasma

Per the Peerless website, this wall mount is compatible with the 58" Panasonic. However, I would only recommend using this mount for such a large/heavy (approx 145 lb) TV based on the location & quantity of wall studs you are able to mount to. If you happen to have the Panny 58" 700U, I strongly recommend you check to see if you have at least 2 wall studs that will be centered (or close to center) behind the TV. I could only mount to 2 studs and they were off center by close to 4". The directions allow the mount to be up to 4" off center, so I decided to keep the mount. However, once I mounted the TV, the wall mount (on the "weak side") pulled away from the wall slightly. I'm confident it will hold the TV but, if I had to do it again, I'd purchase a mount that uses slightly heavier gauge material (I believe Peerless does have a stronger mount available). If you are fortunate enough to be able to mount this wall mount to 2 studs centered behind the TV or, even better, 3 studs or have a smaller/lighter TV, I would not have any problem recommending this unit. One last thing - the installation directions could be better. One statement says always use multiwashers and another entry for my particular TV says the washer isn't needed. Another statement says the braces must be centered on the back of the TV and another says the braces don't need to be centered on my TV. Not a big deal but these obvious conflicting statements should not exist in installation directions.

for more information click here

Easy to install

I bought this to mount a LNT-5265f (Samsung 52" LCD). I wanted a tilting yet low profile mount and this was perfect.

All parts required for the install are included in the package.

The item was packed properly and the included hardware is individually sorted and organized, therefore saving you the time of identifying and sorting the components needed for the install.

Installation was as simple as determining the height of the mounted tv, locating studs, mounting the wall bracket to the studs, attaching brackets to tv and hoisting tv in place. Very simple.

I would like to suggest that you have the following handy for the install.

- Patience. Read the instructions completely before proceeding. This will help you avoid and problems during the install and more importantly it will aid you in planning the install (wall placement).

- A good stud detector to determine the middle of the studs for mounting. I recommend the moderately priced Zircon i65.

- A drill.

- A socket wrench.

Overall...Great product that is easy to recommend to others.

for more information click here